2000G Centrifuge | Drum-Mount | Commercial Grade [US-Filtermaxx]

Get rid of the rust, dirt and water in your fuel! Clean your heating oil with this economical fuel polishing centrifuge.

Got bad fuel? The US Filtermaxx 2,000G Fuel Polisher Centrifuge pulls the junk out of your fuel or heating oil fast. You think your fuel is clean — wait until you see what comes out of it.

See it in action: https://youtu.be/HbpObVb8eZs

2,000G oil and fuel centrifuge. Available in 120V or 240V single phase — select when ordering. Ships with a 6 ft power whip: 3-prong plug (120V) or NEMA L6-20P twist-lock (240V, requires a NEMA L6-20R receptacle).

• Assembly: some assembly required — approx. 30–60 minutes

Key features:

• 2,000G centrifugal force — removes dirt, water, rust and fine particulates
• Smooth bottom feed — gentle, efficient fluid entry
• Large open bowl — high volume per pass
• 3/4 HP dual voltage motor — wired for 120V or 240V to match your selection
• Lightweight and compact — easy to move and install

Typical feed rates:

• Diesel / heating oil polishing: 30 GPH
• WVO: 10–15 GPH

Feed rates vary with oil viscosity and contamination level. Pair with an inline heater for best results on thick or cold oil.

⚠ Never introduce liquid into an empty bowl at full speed. Fill the bowl during start-up acceleration to prevent bowl imbalance.

Centrifugal separation effectiveness depends on the particle class being separated:

• 100–1,500G — Macro/Cellular: whole cells, sand, large debris
• 1,500–10,000G — Microbial/Organelle: bacteria, fine emulsions, oil contamination
• 10,000–30,000G — Subcellular: mitochondria, DNA precipitates

Higher G-force provides better separation quality for finer particles — not necessarily higher flow rate.

For waste motor oil (WMO), we recommend our 3000G or 10000G centrifuges.

Vibration isolator option — select it when ordering to add 3 isolator feet (CST-313), or add them later.

Special PTFE seals are available if needed for your application — request a quote or call 601.651.0007.