{"product_id":"wob-300","title":"200,000 BTU Waste Oil Burner with Compressor","description":"\u003cp\u003eHeat your shop, garage or building for free this winter — using waste oil you'd otherwise dispose of.\u003c\/p\u003e\n\u003cp\u003eThe US Filtermaxx 200,000 BTU Waste Oil Burner isn't particular. It burns virtually any waste oil including: waste motor oil, waste vegetable oil, transmission fluid, heavy gear oil, synthetic oil, hydraulic oil, diesel, waste mineral spirits and glycerin. The adjustable heated feed tank goes up to 250°F — hot enough to make even thick gear oil flow freely.\u003c\/p\u003e\n\u003cp\u003eAdjustable output from 80,000 to 200,000 BTU. Arrives pre-adjusted to approximately 120,000 BTU. Compressor is mounted directly on the burner — no external air supply required.\u003c\/p\u003e\n\u003cp\u003eIncludes: heated automatic oil feed pump, heated oil reservoir tank with adjustable thermostat, Siemens microprocessor controller, Danfoss ignition circuit, air compressor, air regulator, and all braided hoses.\u003c\/p\u003e\n\u003cp\u003eSpecifications:\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003eOutput: 80,000–200,000 BTU (adjustable)\u003c\/li\u003e\n\u003cli\u003ePower input: 208–240V, 150W maximum (blower, heater and pump combined)\u003c\/li\u003e\n\u003cli\u003eFeed tank heater: adjustable up to 250°F\u003c\/li\u003e\n\u003cli\u003eAir pressure: 0.35–0.45 bar operating range, 20 PSI input max\u003c\/li\u003e\n\u003cli\u003eOil input: self-contained heated feed pump with float valve\u003c\/li\u003e\n\u003cli\u003eController: Siemens microprocessor — fully automatic startup sequence\u003c\/li\u003e\n\u003cli\u003eIgnition: Danfoss electronic ignition circuit\u003c\/li\u003e\n\u003cli\u003eOn\/off: toggle switch or thermostat switch (does not require input voltage — use a relay for voltage-output thermostats)\u003c\/li\u003e\n\u003cli\u003eCompressor: mounted on burner — no external air required\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003eHow it works:\u003c\/p\u003e\u003cp\u003eThe burner follows a fully automatic startup sequence: the feed pump fills the oil reservoir, the oil heater brings the oil to temperature, the fan starts and purges the nozzle and furnace for 10 seconds, then the electronic ignitor fires. The electric eye confirms flame before the air valve opens for full operation. The system shuts down automatically if air pressure is out of range or flame is not detected.\u003c\/p\u003e\n\u003cp\u003eCompatible fuels:\u003c\/p\u003e\u003cp\u003eWaste motor oil, waste vegetable oil, transmission fluid, hydraulic oil, gear oil, synthetic oil, diesel, heating oil, kerosene, waste mineral spirits, glycerin. For difficult or contaminated oil, blend 1\/3 diesel to light the burner, then transition to waste oil once lit.\u003c\/p\u003e\n\u003cp\u003eOil quality note:\u003c\/p\u003e\u003cp\u003eOil should be clean and free of debris, water and antifreeze for reliable operation. The US Filtermaxx centrifuge is the ideal pre-treatment system — see our centrifuge lineup for matched oil cleaning solutions.\u003c\/p\u003e\n\u003cp\u003eMaintenance:\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003ePeriodically clean the air input tube with carburetor cleaner to remove deposits\u003c\/li\u003e\n\u003cli\u003eDrain water from the float tank using the ball valve\u003c\/li\u003e\n\u003cli\u003eClean the oil strainer to remove debris\u003c\/li\u003e\n\u003cli\u003eClean nozzle with carb cleaner when cold if coked\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003eFault light reset: turn power off for 5 minutes, correct the fault, then press the reset button.\u003c\/p\u003e\n\u003cp\u003e⚠ Important installation notes:\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003eSupply tank MUST be lower than the burner — siphoning can flood the furnace with oil\u003c\/li\u003e\n\u003cli\u003eBurner exhaust must be vented to the outside — do not operate in a closed building\u003c\/li\u003e\n\u003cli\u003eInstall and operate by qualified personnel only\u003c\/li\u003e\n\u003cli\u003e1-year warranty on defects in materials and workmanship\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003eFor replacement parts for this burner see our 200k BTU Waste Oil Burner parts listings. For a link to parts and accessories visit the US Filtermaxx website.\u003c\/p\u003e","brand":"US Filtermaxx","offers":[{"title":"Default Title","offer_id":47670479421589,"sku":"WOB-300","price":2234.4,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0793\/6606\/2229\/files\/WOB-300_9d5cc607-99cd-4d3f-8a1b-75cbba2c163f.jpg?v=1791477405","url":"https:\/\/usfiltermaxx.com\/products\/wob-300","provider":"US Filtermaxx","version":"1.0","type":"link"}